Michigan dealer product guide

A Champion solution for more homes.

Start with the homeowner’s backup goal, then match the right platform, generator size and smart load-management strategy.

10-year limited warrantyDealer-focused supportAutomatic backup
Champion 8.5, 14 and 26 kW home standby generators
From selected-circuit backup to high-capacity whole-home power.

Choose by customer need

Three clear paths to the right system

Use these families as the starting point. Final sizing should reflect the home’s connected loads, fuel supply and local installation requirements.

Select Circuit fact-sheet preview01

Targeted backup

Select Circuit

8.5 kW12.5 kW

A practical fit when the homeowner wants the most important circuits backed up without powering the entire electrical panel.

  • Up to 12 or 16 selected circuits
  • 50A or 100A transfer-switch options
  • Factory-tested to start up to a 3-ton air-conditioning system
  • Compact 49 × 28 × 28 in. enclosure
View official fact sheet
aXis Whole House fact-sheet preview02

Whole-home simplicity

aXis Whole House

14 kW22 kW

Whole-house automatic backup with digital controls, built-in load-management capability and power-line communication.

  • 100A, 150A or 200A switch choices
  • Smart priority-based load management
  • Gullwing service access
  • 14 kW and 22 kW generator options
View official fact sheet
fleX Whole House fact-sheet preview03

Flexible whole-home platform

fleX Whole House

10 kW15 kW18 kW22 kW26 kW

A broad whole-home lineup designed around easier installation, smarter capacity management and service-friendly access.

  • Four slide-lock service panels
  • 24V starting down to -22°F
  • Up to 20% lower fuel use at average load¹
  • 10–26 kW generator options
View official fact sheet

¹ Compared with leading competitors at average load, as stated in the supplied fleX family fact sheet.

Smarter capacity management

Manage loads from measured amps—not a preset timer.

Champion measures the generator’s actual current on both power legs. During setup, the system learns the managed loads and their priorities. During an outage, it keeps checking available capacity and adds or sheds those loads as household demand changes.

Some frequency-based systems react after generator frequency drops and then use recovery delays. Champion manages from measured current, helping prevent overload before the system has to react to a low-frequency event.

Measures current on L1 and L2Learns loads and prioritiesAdds or sheds loads as demand changesCommunicates over existing power wiring
Champion aXis 50-amp load management module

50A module

Simple In-Line Installation

For a typical 240-volt appliance, the module installs in line with the two hot conductors and ground. No separate control or communication cable is required—the signal travels over the home’s existing power wiring. The module’s neutral bar is not used for a standard 240-volt load; it is available when a 120-volt application requires it.

50A rated load120/240V single phaseNEMA 3R indoor or outdoor enclosure
Representative image shown: Champion aXis model 100868. Installation must follow the current Champion manual, applicable codes and the selected system’s compatibility requirements.
OmniMetrix remote monitoring fact-sheet preview

Optional remote monitoring

See generator status before a truck rolls.

OmniMetrix adds remote visibility across major generator brands, helping dealers monitor system information, receive alerts and review operating history.

System information and historyEmail and text alerts
View monitoring spec sheet

Quick comparison

Match the platform to the opportunity

Decision pointSelect CircuitaXis Whole HousefleX Whole House
Best starting pointEssential circuitsWhole homeWhole home
Available sizes8.5 / 12.5 kW14 / 22 kW10 / 15 / 18 / 22 / 26 kW
Load managementN/APriority basedPriority based
Communication10-wire communicationPower-line carrierPower-line carrier
Warranty10-year limited10-year limited10-year limited

Your next dealer opportunity

Let’s match the right Champion system to your market.

Bring one typical customer home and we’ll walk through the best platform, generator size and transfer-switch approach together.

Chris Jones · Regional Sales Manager · Midwest · 562-309-4725